The WILAPLAT Electrolytic Degreasing Bath ZFM is a highly alkaline degreasing solution for the cathodic cleaning of all precious and non-precious metal alloys.

The work pieces to be treated are first cleaned in the ultrasonic bath, rinsed and then attached to the cathode rod in the electro-plating unit. Upon completion of the exposure time the work pieces are removed and thoroughly rinsed in water. It is absolutely essential to avoid drag out of the degreasing solution to other baths.

Data:

• Temperature (°C): 15 - 30
  
• Exposure time (sec): 30 – 180, (max. 60 for non-ferrous metals)
  
• Voltage (Volt): 6 – 8
  
• Current Density (A/dm²): 5 – 15
  
• Anodes: Stainless steel
  
• Tank Material: Stainless steel or plastic (PA,PE,PTFE, ABS)
  
• Making up: 50g/l dissolved in warm water

Supply form: make-up salt
Content (g): 50
Original Wieland n°: 3040400103
Hazardous material: YES
Regeneration: not recommended.

Note according to REACH Regulation (EC) No. 1907/2006:

This product contains chemical substances that are subject to labelling requirements under the REACH and CLP Regulations.
The applicable Hazard statements (H-statements) are:

• H314 – Causes severe skin burns and eye damage.
  
• H335 – May cause respiratory irritation.

Please also observe the following Precautionary statements (P-statements) for safe use:

• P303+P361+P353 – IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower.
  
• P305+P351+P338 – IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do. Continue rinsing.
  
• P310 – Immediately call a POISON CENTER/doctor.
  
• P321 – Specific treatment (see on this label).
  
• P405 – Store locked up.
  
• P501 – Dispose of contents/container in accordance with local/regional/national/international regulations.